Spindle Speed Label for Mini Lathes
SKU:
$7.49
$7.49
per item
The Spindle RPM Label from Phenom Engineering allows you to set your spindle to the speed you need. In low gear, the label is marked in 100RPM increments and in high, 250RPM increments. The label also shows the 'dead' zones of the speed controller (the areas where turning the knob does not change the spindle speed). The label has been independently shown to be accurate to +/-10 RPM at all speeds and is repeatable to within +/-2 RPM (these variations are due to the inconsistencies of the controller). The label is made from high quality vinyl and is repositionable, to make installation as easy as possible. The stickers are fade, moisture and UV resistant.
Installation of the label is done by simply removing the speed control knob, lining up the edges of the label and then pressing the label into place right on top of the original. Lastly, line up the knob with the 'OFF' line and tighten.
This label is die cut to fit the newer 7x10 and 7x12 lathe models (control panel shown to the left). It will work for any 7x10 and 7x12 lathe, but may require trimming to fit your particular brand of lathe, depending on model and year.
Installation of the label is done by simply removing the speed control knob, lining up the edges of the label and then pressing the label into place right on top of the original. Lastly, line up the knob with the 'OFF' line and tighten.
This label is die cut to fit the newer 7x10 and 7x12 lathe models (control panel shown to the left). It will work for any 7x10 and 7x12 lathe, but may require trimming to fit your particular brand of lathe, depending on model and year.
The label should also work on the 7x14 lathes with the higher output motors, but has not been independently verified, so this can not be guaranteed.
Shipping Weight: 0.13lb